JSON-LD markup generated by Google Structured Data Markup Helper.

2014 BMW X1

  • 2014 BMW X1

    BMW X1
    Mileage
    87,623
    Service Date
    9/23/2024
    Services Performed
    • Includes: Change engine oil and filter. Check transmission fluid level and adjust as needed. Check coolant condition and pressure check system. Check brake fluid level and condition. Check power steering fluid level and condition. Check belts; coolant, fuel, and vacuum hoses for damage/degradation. Check antenna operation (if applicable). Lube all doors and latches. Tighten door brake fasteners. Lube hood hinges and latch. Check differential fluid level. Check axle boots, CV joints, and/or U-Joints for damage. Check wheel bearings for play. Check parking brake operation. Check for fluid leaks. Check interior and exterior lights. Check wiper and washer jet operation. Check tire wear and condition. Set tire pressures to specification. Vacuum cowl. Check intake and cabin air filters. Test drive vehicle.
    • Replace wiper blades on vehicle.
    • Check coolant level and condition. Pressure test cooling system for leaks. Inspect hoses and cooling system components. Check operation of cooling fans. Found coolant level slightly low, but still present in reservoir. Pressure tested cooling system during service, no pressure loss present. With splash shields removed, checked for any signs of coolant buildup or residue. None visible at this time. Topped off coolant. Recommend monitoring vehicle for any return of low coolant warning.
    • Replace engine air filter.
    • Replace cabin filter element. Reassemble filter housing and access panels.
    • Replace rear brake pads. Clean mounting surfaces. Replace wear sensor as required. Replace brake rotors. Lubricate caliper slides. Adjust parking brake mechanism. Road test vehicle.
    • Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Drain and refill entire brake system including master cylinder, calipers, wheel cylinders. Bleed system until clean fluid is seen.
    • Removed engine covers and intake piping. Released belt tensioner and removed drive belt from engine. Inspected pulleys and engine accessories for any play, noise, or roughness. Routed new drive belt and released tensioner. Reinstalled intake piping and engine covers.
     
    Cristina V. gave our service a 5 star review on 10/11/2024

Address

Oren's Automotive
227 Gray Ave
Santa Barbara, CA93101
(805) 965-6142

We Service