JSON-LD markup generated by Google Structured Data Markup Helper.


Home / Infiniti

We Service and Repair all Infiniti cars

  • 2014 Infiniti QX60

    Infiniti QX60
    Service Date
    Services Performed
    • Includes: Change engine oil and filter. Check transmission fluid level and adjust as needed. Check coolant condition and pressure check system. Check brake fluid level and condition. Check power steering fluid level and condition. Check belts; coolant, fuel, and vacuum hoses for damage/degradation. Check antenna operation (if applicable). Lube all doors and latches. Tighten door brake fasteners. Lube hood hinges and latch. Check differential fluid level. Check axle boots, CV joints, and/or U-Joints for damage. Check wheel bearings for play. Check parking brake operation. Check for fluid leaks. Check interior and exterior lights. Check wiper and washer jet operation. Check tire wear and condition. Set tire pressures to specification. Vacuum cowl. Check intake and cabin air filters. Test drive vehicle.
    • Test drove vehicle to check for noise. Inspected vehicle for exhaust leaks with it running on lift. No exhaust leaks present. Removed drive belt and checked for noise from tensioner or other engine accessories. All ok. Noise still present when vehicle is running without belt. Noise is not a safety issue. Further investigation required to pinpoint source of noise.
    • Replaced engine air filter.
    • Replace rear brake pads. Clean mounting surfaces. Replace wear sensor as required. Replace brake rotors. Lubricate caliper slides. Adjust parking brake mechanism. Road test vehicle.
    MIKE V. gave our service a 5 star review on 7/8/2022
  • 2005 Infiniti QX56

    Infiniti QX56
    Service Date
    Services Performed
    • Inspected washer system. Found washer pump covered in glue and fluid reservoir half full. Checked for power and ground at pump, OK. Removed air intake and inspected reservoir. Reservoir has no leaks visible. Fluid in reservoir smells like a bug cleaner additive was used. Recommend replacement pump prior to further diagnosis. Removed air filter housing and intake piping. Removed wiring and hoses from pump assembly. Removed pump from reservoir and drained fluid. Flushed reservoir with water to remove any residue from previous cleaner. Installed new pump and grommet. Filled reservoir with water to check for leaks. None present. Connected wiring to pump and tested pump operation. Pump outputting water normally. Reconnected hoses and tested washers. Front washers working properly. Rear washer working too. Topped off washer reservoir with washer fluid concentrate. Reinstalled intake piping and air filter housing.
    Barbara M. gave our service a 5 star review on 11/3/2021